- What is the minimum clearance between a crane and powerline?
- How often should a crane be serviced?
- What is a suspended load in geology?
- Is it safe to stand under suspended loads?
- Under what conditions is it safe to stand on a suspended load?
- Can you work under a crane boom?
- What does suspended load mean?
- How fast does a crane have to stop according to OSHA?
- When should a crane be officially inspected by a qualified person?
- What are the hazards in crane lifting?
- What is a live boom?
- Who needs a crane certification?
What is the minimum clearance between a crane and powerline?
10 feetFor lines rated 50 kV.
or below, minimum clearance between the lines and any part of the crane or load shall be 10 feet; b.
For lines rated over 50 kV., minimum clearance between the lines and any part of the crane or load shall be 10 feet plus 0.4 inch for each 1 kV..
How often should a crane be serviced?
every 12 weeksSome crane manufacturer’s might specific more frequent inspections than this depending on the slights and the amount of use, but as a general rule a full inspection should be every 12 weeks.
What is a suspended load in geology?
The suspended load of a flow of fluid, such as a river, is the portion of its sediment uplifted by the fluid’s flow in the process of sediment transportation. It is kept suspended by the fluid’s turbulence. The suspended load generally consists of smaller particles, like clay, silt, and fine sands.
Is it safe to stand under suspended loads?
The Dangers of Working Under a Suspended Load Even a small overhead load can become lethal. If a load falls, it can quickly break and split, becoming a series of injurious and deadly projectiles. Harmful splashes, flooding, shattered bones, and injuries to the eyes, head, and soft tissues can occur.
Under what conditions is it safe to stand on a suspended load?
The fall zone as defined by OSHA is “the area including, but not limited to, the area directly beneath the load in which it is reasonably foreseeable that partially or completely suspended materials could fall in the event of an accident.” OSHA goes on to state that standing under a suspended load is prohibited and …
Can you work under a crane boom?
The rule is simple: “Don’t stand, walk, or work under crane booms, buckets or suspended loads.” Prior planning of crane operations usually takes into account the area to be covered by the swing of the boom. … Employees should stay clear when the crane operator is landing the bucket and during the take-away.
What does suspended load mean?
Suspended load refers to that part of the total sediment transport which is maintained in suspension by turbulence in the flowing water for considerable periods of time without contact with the stream bed. It moves with practically the same velocity as that of the flowing water..
How fast does a crane have to stop according to OSHA?
The bumpers shall be capable of stopping the crane (not including the lifted load) at an average rate of deceleration not to exceed 3 ft/s/s when traveling in either direction at 20 percent of the rated load speed.
When should a crane be officially inspected by a qualified person?
(1) – At least every 12 months the equipment must be inspected by a qualified person in accordance with paragraph (d) of this section (each shift) except that the corrective action set forth in paragraphs (f)(4), (f)(5), and (f)(6) of this section must apply in place of the corrective action required by paragraphs (d)( …
What are the hazards in crane lifting?
Lifting & Crane Hazards:Falling of load.Hitting & crushing of a load to existing facilities.Toppling of Crane.High wind speed, Poor communication and poor visibility.Damage to underground utilities of earth.
What is a live boom?
Some older cranes are designed with a “live boom,” where the rate of lowering the boom can only be controlled by a brake. … the equipment is a floating crane/derrick or a land crane/derrick on a vessel/flotation device.
Who needs a crane certification?
Operators of most cranes above 2,000 lb. capacity when used in construction will need to be either certified by an accredited crane operator testing organization, such as the National Commission for the Certification of Crane Operators (NCCCO), or qualified through an audited employer program [§ 1926.1427(a)].